Tube angled forward to allow skipper to sit a bit further forward without stepping over with leg.
Controlls on the sides / on seat tank 2 cleats for jib block up/down and in/out,
both sides linked and symetrical.

Controlls going out from cap to recess on both sides are, starting from back:
Kicker, forestay/rake, shrouds, mast ram down front one not going out is ram up.

Vertical system workes very easy even under load going upwind.
Pin is sliding in the track and as it stands out at top (but out of the way as beside
the head of board) it can also be pushed down again. Both ropes go back to skipper
and is continues rope as lifting is same amount of rope as dropping again.
So no loose loop of rope lying around in boat.

Notice the strong reinforced front thwart.
There is also a strong reinforcement inside the side tank to take
the high sideways load at top of case caused by long board.
Tom Swift (current owner) only changed 8775 to transom sheeting.

**Holger Jess**

New stainless steele transom fittings which have 10mm pin. This is what we use since last year. Rudder fittings from Holt with holes enlarged to 10mm.

Sidan uppdaterad 2003-08-14 22:25 av Ebbe Rosén

SvenskaFörbundet